There are many reasons why a car leaks rain

Leakage of a car is a common phenomenon. Leakage usually occurs at the door and trunk switch. Most of the reasons for this happening are the waterproof strips, that is, the poor weather of the plastic waterproof strips, aging, or breakage, and the rainwater will infiltrate from there. Re-adhesion with a special adhesive for waterproof tape can completely prevent water leakage.

Generally, the rainwater leaks from above, but there is also a counterflow from the bottom. The reason for this is that the rubber plug of the floor deviates. There are several holes in the bottom plate, and the plastic plug is embedded from above. After this deviation, the interior of the car becomes a direct connection with the ground. When heavy rain occurs, the rainwater seeps into the bottom. When the floor is wet, it should first be suspected here.

General automobile leakage is nothing more than the following: Waterproof strips that are embedded around the door are easily deflected. If rainwater enters the vehicle, check the waterproof strips. Stick the loosened strips and reattach them with special adhesives. Restore the sealing performance so that it will not leak anymore. The old car should also pay attention to the aging of the waterproof strip. Leakage around the door is mostly due to the sticking of the waterproof strip around it. Check for cracks and flaking; Twisted, rainwater often flows in from there and needs to be replaced when it is severely deformed. When peeling off, it is re-adhesively applied using a waterproof adhesive called a sealant. Be careful not to pull it so as to avoid injury. When a small amount of looseness is difficult to stick, Simply peel it off and then stick it. This will fix the distortion and slackness of the waterproof strip. There are also waterproof strips around the trunk, often with tight and twisted bends and rainwater dripping from the cracks. Peel off the waterproof strip. After the adhesive is applied, apply a protective agent for rubber to restore the elasticity. This can be solved. Open the floor mat to expose the plastic plug. If the plastic plug comes off, the water will be immersed in the car from the road surface. The same trunk, check the bottom of the rubber plug is fully fitted.