Rapid intelligent sulfur analyzer maintenance:
1. After electrolysis occurs in the electrolysis cell, the electrolysis cell should be opened, and the electrode should be scrubbed with ethanol or acetone to make the electrode appear bright silver-white. The stain can be handled carefully with fine paper or a knife, and impurities can not be left on the electrode. Attachments, and then scrub the plexiglass wall of the electrolytic cell with an organic solvent such as ethanol or acetone to prevent possible shell cracking.
2. Sintered glass melting plates and their pipelines should be cleaned in a timely manner when there are black precipitates.
3, rubber pipe connected to the gas line should always check, the joints at the most vulnerable to aging and leakage, the timely use of new leaks.
4. The small porcelain boat that holds the coal sample should be kept in a clean container. The new porcelain boat should be treated with high temperature before it is used for the first time. The porcelain boats with coal samples that have been weighed should be particularly careful not to be contaminated by coal-coated hands or tables. It is better to have white porcelain plates that are specially placed on porcelain boats.
5, regular calibration with standard instruments to check whether the instrument is normal, so as to ensure the use of the instrument, and check whether the reducer is broken, the electrolytic cell pole piece is polluted, air leakage and so on.
6. If you want to reset the temperature control point due to special use, press and hold the "Set temperature" button on the panel to adjust the "set temperature" hole bored, so that when the temperature indicates the set value, release " Set temperature key.
7. The instrument should prevent the intrusion of dust and corrosive gases and put it in a dry environment. If it is not used for a long period of time, it should be properly covered and regularly powered on to bake moisture inside the instrument. If the electrolysis cell is not used for a long time, the connecting hose should be removed to prevent its aging and adhesion.
Brick Making Machine
In a large industrial brick making machine, clay is taken from the quarry, and then carried by conveyor belt or truck/lorry to the main factory, although it may be stockpiled outside before entering the machinery. When the clay enters the preparation plant (Clay Prep) it is crushed, and mixed with water and other additives which may include breeze, a very fine anthracite that aids firing. This process, which is also known as pugmilling, improves the consistency, firing qualities, texture, and colour of the brick. From here, the processed clay can be extruded into a continuous strip and cut with wires, or put into moulds or presses (also referred to as forming) to form the clay into its final shape. After the forming or cutting, the bricks must be dried, either in the open air, in drying sheds, or in special drying kilns. When the bricks have been dried, they must then be fired or 'burnt' in a kiln, to give them their final hardness and appearance.
Brick Making Machine,Clay Brick Making Equipment,Clay Brick Making Machine,Brick Making Equipment
SHANDONG SHINE MACHINERY CO.,LTD , https://www.shinebatchplant.com