In summer and winter, windshields are prone to problems such as blurred mirrors or mirror reflections. Drivers can easily confuse the sight and affect driving safety at night or when the weather is not very good. In summer, there is a lot of rain, and many glassy insects like shellac or traces of rain leave behind the surface of the glass. In winter, rain and snow can easily cause frost to form on the mirror. These problems seem simple, but they are dealt with. not simple. The windshield of a car is like the eyes of a car and can determine whether the driver's eyes are clear or not.
Some owners think that cleaning glass can only be cleaned and decontaminated. Therefore, using detergent or detergent to replace glass water, some car owners plan to use cheaper water instead of direct water. These are hidden problems. There are some deposits in chemical detergents such as washing powder. It takes a long time to easily corrode the rubber tubes, and it will block the water outlets. In severe cases, it will damage the motor. General detergents also continuously corrode the rubber tubes and accelerate the hardening of the catalytic wiper strip. When the hardened adhesive strip scratches the windshield, it accelerates the scratches and scratches on the windshield surface. If the wiper is replaced again, the cost will be several ten times that of glassy water. Although the ordinary clean water is very clean, there are also many chemical residues inside, and over time, it can cause the water outlet to clog and affect the water spray. If you use it for a long period of time, the frictional force of the mirror will increase, and the wiper will easily leave a slight scratch on the mirror surface during cleaning.
In the ordinary glass maintenance process, it is necessary to select suitable glass water according to the season and the specific conditions of the weather. When it is found that the surface of the windshield glass is blurred, cleaning with suitable glass water will be much brighter. In the evening, the problem of glass reflections can also be wiped with glassy water. In addition, in the case of running high speed or dusty conditions, glass water can be used very quickly, and it is necessary to pay attention to the injection of new glass water immediately.
Always pay attention to the proper use of glass water. Invisibly buy a high level of insurance for your vision.
The main components of Shine core Veneer Dryer is as follows:1.Drying system :the veneer dryer adopts the most scientific drying principle ,and the hot air in the hot air stove is injected directly into the upper and lower bellows of the machine by centrifugal blower. The hot air blows to the upper and lower sides of the running veneer through the nozzles of the upper and lower bellows, so that the veneer is heated evenly and thus plays the role of drying 2.Control system: Adopt endless gearbox to adjust feed speed according to your veneer thickness and moisture content to achieve ideal drying effect. 3.Transmission system :the veneer is fed into the machine through the feed inlet vertically, and the chain drives the upper and lower rows of rollers, running relatively. The veneer moves forward by the self-weight pressure of the upper roll, and during the veneer passes through the two rollers and the upper and lower air nozzles, it achieves the effect of drying and ironing. So the veneer dried by this machine is flat, smooth and without marks. 4.Heating system:Steam heating, heat conduction oil heating, hot stove type heating,waste wood or other biomass materials. Users can choose one most suitable model. but biomass fuel is the most economic one which can save the drying cost to the user to the most .
Branch Shredder,Core Veneer Dryer,Plywood Veneer Dryer,Plywood Veneer Dryer Machine
Shandong Shine Machinery Co.,Ltd , https://www.shinewoodmachine.com