There are a lot of people who are not very familiar with the precautions of the cabinet centrifuge. Here are some tips for you.
When installing a wind cabinet, the following requirements should be followed:
1. When used for fire fighting, the smoke exhauster and the smoke exhauster should be equipped with an interlocking device. When any one of the exhaust vents is opened, the smoke extractor can be automatically activated.
2. The air installed in the fan is entrained with viscous substances. The content of dust and hard particles should be no more than 150mg/m3.
3. When installing the fan, there should be a vibration damping device, and the ceiling installation should be fastened securely.
4. When power is supplied from the socket, the power cable of the fan should be equipped with a plug that meets the safety standard; when the power cable of the fan is directly connected to the power supply line; the power supply line should be equipped with an all-pole power supply with a contact opening distance of at least 3 mm. switch. Motor protection should be installed during power distribution. Power motors with 7.5Kw and above should have a step-down starting device.
Installation method
The first type: ceiling installation
1. Fix the angle steel to the roof with bolts.
2. Sew the steel plate from the bottom of the body at an appropriate position, and then bolt the flat plate to the hoisting angle to secure the fan to the roof.
3. Install pipe and fan air outlet, tighten with rubber rubber
4. For those who have special requirements for height reduction, the customer can put the external motor on the side of the box and flush it on the sole of the foot.
Second: seated installation
1. Pre-embed the bolt on the bottom plate according to the position of the mounting hole.
2. Fasten the bottom of the body to the ground with bolts
3. Install the pipe at the fan outlet and tighten with rubber rubber
Contact down force is one of the most important factors in achieving a properly crimped pMDI canister. This precision device measures the contact down force in deka Newtons (daN) applied to the valve during the crimping operation.
· MDI direct placement transducer
· 0 to 200 daN Digital Readout
· RS232 Computer Interface
Gauge Equipments,Down Force Equipments,Digital Push Pull Force Test Equipment Force Gauge,Down Force Gauge Equipments
Anomatic(suzhou)metal packaging co,ltd , https://www.anomaticpharma.com