[China Instrument Network Instrument R&D] Recently, Dr. Wang Dazhi, the General Research Office of the Institute of Optoelectronics Microelectronics, successfully developed the first full-position gyro-based north solver in China with the support of the National Natural Science Foundation of China.
All-position gyro north seek solver
The gyro north seeker is an autonomous north seeking inertial meter and is mainly used to determine the azimuth datum that the specific system aims and measures. The conventional gyro north seekers are required to work in the horizontal state, and they cannot find the north when they are tilted. This forms a traditional work mode of “first leveling and then seeking northâ€. However, leveling is time-consuming and laborious, especially for high-precision, rapid leveling of large-scale vehicle platforms. For a long time, people have been devoted to the development of a leveling system with better performance and higher precision, but the effect is not ideal.
The research team of the Institute of Optics and Electronics has taken the initiative to adopt the innovative approach of “not leveling and direct seeking for the North†and broke through the traditional mode of “norm leveling and afterward seeking†to find the north instrument. The successful development can achieve precision in large tilt range. North-seeking full-finger gyro north seek solver. The successful development of this instrument has filled the technical gap in the domestic northward tilting search. It is a major technological advancement in the field of inertial north seeking and is of great significance to the realization of high-precision motorized aiming and measurement in China.
At present, the project team is actively promoting the further application of the instrument and promoting the technical transformation of relevant results.
(Original title: The Institute of Optoelectronics has successfully developed the first all-position gyro north seek solver in China)
Adsorption Dryer is another type of dryer used to get rid of water in compressed air. It achieves drying effect by "pressure change" (pressure swing adsorption principle). Because the moisture containing
capacity of air is inversely proportional to pressure, part of the
dried air decompresses to atmospheric pressure, this pressure changes
makes the
expanded air gets drier.Then let it pass through adsorption tower which
need regeneration, the drying regeneration air extract water, then take
the water out of adsorption tower. So adsorption dryer normally are of twin tower
construction. One tower dries the air from the compressor while the
desiccant in the other tower is being regenerated after the pressure in
the tower has been reduced to atmospheric pressure.
There are two types of adsorption dryers: heatless adsorption type, no internal or external
heaters are used, and heat adsorption dryer, which need a heater. Compared with Refrigerant Dryer, the advantage of adsorption dryer is its drying performance is beter, but its disadvantage is this kind of dryer consumes compressed air, which makes operation power consumption bigger.
Adsorption Dryer
Adsorption Dryer,Adsorption Air Dryer,Adsorption Compressed Air Dryer,Regeneated Adsorption Air Dryer
Shandong Gamma Gas Engineering Co. Ltd. , https://www.gammagas.com
